Modify Selection
- Hazard prevention and control:
- Methane control
- or
- Degasification
- or
- Gob gas vent holes
- or
- Horizontal boreholes
- or
- Cross measure boreholes
- or
- Bleeder systems
- Document types:
- Reports of Investigations
Home Links
Results 1 - 10 of 53
-
This NIOSH publication demonstrates how existing and new engineering controls can be used to reduce face methane levels.
-
10/1/1999 - Reports of InvestigationsAn analysis of the consequences of increasing longwall panel dimensions, particularly face width, in gassy coalbeds. Continuous longwall face emission monitoring studies were conducted at two adjacent mines operating in the Pocahontas No. 3 Coalbed, whe...
-
1/1/1992 - Reports of InvestigationsFour coreholes were drilled at a longwall mine in the Lower Kittanning coalbed to obtain coal and rock samples from overlying strata to determine their gas content during the mining cycle. Test results indicate that 91% of the gas came from coalbeds.
-
1/1/1990 - Reports of InvestigationsThe Bureau of Mines preproduction wireless survey system (WSS) and its performance during an in-mine test are discussed in this report. The WSS was developed to reduce downhole surveying time in order to increase the efficiency of drilling long horizont...
-
1/1/1989 - Reports of InvestigationsThe U.S. Bureau of Mines used a contact drilling strategy with short-collared assemblies in order to rotary drill long horizontal methane drainage holes in the Beckley coalbed near Glen Daniel, West Virginia. By decreasing the thrust and increasing the ...
-
1/1/1988 - Reports of InvestigationsThe Bureau of Mines conducted an investigation into the occurrence of outbursts of salt known to be responsible for explosions, fatalities, and damage in domal salt mines. The purpose of the investigation was to develop a basis for predicting these outb...
-
1/1/1987 - Reports of InvestigationsGob holes are routinely used by the mining industry to vent methane from gobs and to prevent it from entering the mine ventilation system. In some cases, flows from gob holes are measured by centering an anemometer on the end of a discharge pipe. These ...
-
1/1/1986 - Reports of InvestigationsThe Bureau of Mines conducted studies to compare the effectiveness of the cross-measure borehole system with that of surface gob holes on two successively mined retreating longwalls in the Lower Kittanning coalbed. Only the cross-measure system was in o...
-
1/1/1986 - Reports of InvestigationsAn investigation of the effectiveness of methane drainage in the lower Sunnyside coalbed at Kaiser Steel Corp. Sunnyside No. 1 Mine in Utah. Most previous attempts to drain methane gas using long horizontal holes were conducted in the eastern coal provi...
-
1/1/1985 - Reports of InvestigationsThe cross-measure borehole technique is an effective method of controlling methane liberated by fracturing the roof strata in longwall gobs where overburden is less than 750 ft (229 m). About 71 pct of the methane produced by longwall mining in the Lowe...
Home Links
Content source: National Institute for Occupational Safety and Health, Mining Program